Whirlpool 3354199 Інструкція з монтажу Посібник з монтажу - Сторінка 5

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Пральна машина Whirlpool 3354199. Whirlpool 3354199 8 сторінок.

Друкувати сторінку

level, screw the front legs up or

down to adjust. Make final check

with level.

When washer is level, use

wrench to turn nuts on front

legs up tightly against washer

base. If nuts are not tight

against washer base, the

washer may vibrate.

On coirroperated

washers, remove

the service door of the meter case.

Lift the service door up at the back

and remove. Carefully insert coin

slide with the coin slide extension

attached

into front opening and

secure with the %" mounting bolt

from inside the meter case. The coin

slide may need to be partially

pushed in to insert mechanism

in the front opening. Replace

meter

case top and service door. Insert coin

vault with lock and key.

Check that all parts are

now installed. See parts

list, Page 2. If there is an extra part,

go back through steps to see

which step was skipped.

Turn on water faucets

W and check for leaks.

Tighten couplings if there is leaking

Untape electrical cord

and plug into

grounded outlet.

Put the coin vault with lock

and key in the meter case

opening.

A larger capacity

coin vault

can be installed. Use a knife to carefully

remove the paint along the seam at the

bottom

of the conversion

bar. Use a

blade screwdriver

and a hammer to

lightly tap along the seam area. Raise

the conversion

bar up to the notches in

the sides of the vault opening.

Remove

the conversion

bar and drawer guide.

Install new guide (found in parts bag)

and the larger coin vault.

CHECK ELECTRICAL

REQUIREMENTS. BE SURE

YOU HAVE CORRECT ELECTRl6Ai

SUPPLY AND RECOMMENDED

GROUNDING METHOD.

Check that you have all tools that you

started with and that the shipping

strap with its 3 cotterpins and plug

was removed from the washer.

if entire strap is not removed,

washer may vibrate and be noisy.

23.

Check the wash cycle time. Both coin-

operated

and non-coin operated

washers have timers with a 9-minute

wash in the Normal cycle. Remove the

meter case top of coin operated

washers to manually start the timer.

Remove the rear of the console to

manually operate the timer of non-

coin operated

washers. Start the

washer and allow it to complete

the

Normal cycle.

Rotate

counter-

clockwise

only

. '3

\ '6

lit&

"off"

posltlon

Timer

Wont

Coin-operated

timers can be started

by turning the clutch assembly

counter-clockwise

until the washer

starts to fill with water.

-I

Pull to start

Push to stoa

Timer-rearview

Non-coin operated timer cycle

information is ink stamped on the

rear of the timer. Push in on the lever

attached to the timer shaft. Reset

lever to the Normal cycle position

then pull out on lever to start washer.

If the washer fails to start

W or does not give the

proper wash cycle time, the clutch

assembly of the coin operated

can

be adjusted. Remove the timer from

the meter case. Adjust the clutch

assembly screw clockwise, if the

washer does not start after the coin

slide mechanism has been fully

actuated

in or out. Adjust the clutch

assembly screw counterclockwise

the wash segment of the Normal

cycle was less than 9 minutes.

YiiiiT'mer

I\'

\ .a

<mer

clutch

adjustment

screw

PAGE 4