Alcolock IGNITION INTERLOCK WR3 Інструкція з експлуатації - Сторінка 4
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Випробувальне обладнання Alcolock IGNITION INTERLOCK WR3. Alcolock IGNITION INTERLOCK WR3 16 сторінок.
Друкувати сторінку
BASIC OPERATIONS
STARTING
Wait...
Ready for test
1
1. If the display screen is blank, press the right button to wake up
the unit.
NOTE: The ignition key must be in the OFF position before
proceeding further.
The screen will display Wait and the status light will be flashing
amber.
2. Wait for the Handset to display Ready for test and the status
light to change to flashing green. The wait time will vary with
the ambient temperature.
3. Insert a mouthpiece into the Handset.
NOTE: You should not eat or drink anything for at least 10-15
minutes before taking a test.
4. Blow into the mouthpiece with moderate force for 3 seconds,
then make a "Hum" sound while continuing to blow for the
remainder of the test. The WR3 will generate a continuous
tone to indicate adequate air flow. Do not stop blowing until you
hear a beep from the Handset. The Handset will display Wait,
followed by the test result.
If you blew incorrectly, the test will be aborted and the Handset
will display Hum louder, Blow softer Blow longer, Blow
longer and harder or Blow then hum. Wait for the Handset to
display Ready for test before trying again.
ALCOLOCK WR3