ALcom CL-3121 IDM Посібник користувача - Сторінка 10
Переглянути онлайн або завантажити pdf Посібник користувача для Бездротовий телефон ALcom CL-3121 IDM. ALcom CL-3121 IDM 13 сторінок. Ultra clear long range caller id cordless phone
Друкувати сторінкуPAGE 14
Transferring Calls (Cordless Handset to another Cordless Handset)
If extra cordless handsets are set to the base unit,
1. In talk mode, press
INT/TRANS.
button then the other cordless handset number. The outside
line will be on hold and make music sounds to the other end. Both the two cordless handsets
will ring.
2. If the other cordless handset user does not answer, press
to the call.
3. The other cordless handset user can press
automatically after receiving the transfer ring.
4. If the other cordless handset does not respond within 25 seconds, the line will disconnect
automatically.
NOTE:
There is no intercom between the handsets.
3-B. Intercom function
You can have a two-way conversation between the cordless handset and base unit through the
intercom feature.
Activating the Intercom With the Base Unit:
1. In standby mode, press
INT
button then press the cordless handset number, the base and
cordless handset will ring.
2. The base unit user can cancel the intercom by pressing
or pick up the corded handset.
3. The cordless handset user can respond by pressing
USE on base unit and channel number on cordless handset. The both unit enter into the
intercom state. The base unit can talk in
SPEAKERPHONE
4. The cordless handset user can end the conversation by pressing
INT/TRANS.
button or put the cordless handset on charger.
PART 3: Special functions
TALK/ST-BY
button again to return
TALK/ST-BY
button to answer the call
INT
button or
SPEAKERPHONE
button
INT/TRANS.
button, the LCD shows HS-1
mode or pick up the corded handset.
TALK/ST-BY
button or
PART 2: Telephone Operations
PART 2: Telephone Operations
2-A. Digital Security
IMPORTANT NOTICE: The base unit and the cordless handset in your hands have been
already factory code set.
If you need to register the code again, please do as follow:
1. Make sure the base unit is connected into the AC power outlet.
2. Press and hold
CODE
button on the base unit.
3. Press and hold
CH.
button on the cordless handset. The handset will make a sound for
confirmation of code setting and the LCD will indicate the handset No(
button.
4. If you have more than one handset, pick up the second handset, press and hold
until you get a beep and display
- 2. If you have the third handset, continue the same
procedure. If not, release the
CODE
button on the base unit.
NOTE
: The
CODE
button on the base unit should be kept pressing during the whole procedure.
2-B. Handset On/Off Switch
* In the standby mode, press
DEL/
button for about 3 seconds and the power turns off,
will show on the LCD. In this mode, all functions are invalid but to recharge.
* Press
DEL/
button again for about 3 seconds and the power turns on, and the LCD shows
real time, you can do any operation in this mode.
ATTENTION!
When the
OF
and the
the unit need to be recharged, you can not do any other operation but to
recharge the battery. When the power is full, the OF will disappear
automatically and the battery icon shows as
PAGE 7
-1). Then release
CH.
low battery icon
show on the LCD,
.
CH.
button
OF