Xerox 460 Посібник зі швидкого встановлення - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник зі швидкого встановлення для Ксерокс. Xerox 460. Xerox 460 38 сторінок. Macintosh driver information
Також для Xerox 460: Інформаційний посібник (13 сторінок)
100BaseT Ethernet or Token Ring Interface Quick Install Card
Xerox Document Centre 460/470 ST
Before You Connect to a Token Ring-
Network
If your printer is equipped with a Token Ring
interface, to avoid problems with your network
you must set the Ring Speed and Source Rout-
ing settings for your environment prior to con-
necting the printer to your network.
The default settings for the Token Ring interface
Ring Speed and Source Routing are 16Mbps
and None. If you do not need to change these
values for your network you do not need to per-
form the procedures on this card.
As with any other Token Ring device, connecting
the Document Centre 460/470 Token Ring inter-
face to your network while it is set at the incor-
rect Ring Speed can cause severe problems on
your network.
Before you connect the printer to your network,
perform the procedure in the next column on this
page entitled Go to the printer and...
Go to the printer and...
1.
Enter the Tools pathway
a)
Press the Access ( ) button.
b)
On the keypad enter 1111 or the
current password. Press the Enter
button when finished. Press the Go to
Tools button.
c)
The Touch Screen will be used for the
remainder of the data entry.
2.
Set or Change the Ring Speed or Source
Routing
a)
Press the Connectivity and Network
Setup button.
b)
Press the Physical Media button.
c)
Press the Token Ring button.
d)
Press the Token Ring Settings
button.
e)
Select the desired Ring Speed (4 or 16
Megabits per second).
f)
Select the desired method of Source
Routing (None, Single Route
Broadcast or All Route Broadcast).
g)
When finished with your changes
press Save.
Page 2
3.
Change your printer's MAC Address.
Perform this step ONLY if required by
your network environment. Otherwise
skip to Step 4. All Token Ring interfaces
are assigned a default MAC address from
the factory.
a)
Press the MAC Address button
b)
Enter the six (6) hexadecimal pairs on
the touch keypad separated by colons.
c)
When finished press Save.
4.
Press the Exit Tools button.
5.
Wait a MINIMUM of 7 minutes for the
printer to reset.
a)
Obtain a Configuration Report page
from your printer and verify that your
Token Ring Settings have been
retained.
6.
Connect your Document Centre to the
network with the appropriate cabling.