Xerox 460 Посібник зі швидкого встановлення - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник зі швидкого встановлення для Ксерокс. Xerox 460. Xerox 460 38 сторінок. Macintosh driver information
Також для Xerox 460: Інформаційний посібник (13 сторінок)
Друкувати сторінку
Static (Manual) TCP/IP Addressing Quick Install Card
Xerox Document Centre 460/470 ST
Before You Start
To enable 100BaseT or a Token Ring interface,
refer to the 100BaseT Ethernet and Token
Ring Interface Quick Install Card to configure
the Speed and Source Routing settings for your
environment. Then return to this card and
perform the procedure here.
NOTE: By default, DHCP is enabled on the
Document Centre. This card will show you
how to disable DHCP and manually set your
TCP/IP information.
Your Document Centre supports printing from a
variety of operating systems that support TCP/
IP.
Review the Quick Install Cards that were
supplied with your printer. If there is no specific
card for your type of TCP/IP network, the
procedure contained on this card will enable you
to connect your printer in any TCP/IP
environment:
Record the following information:
IP Address ____________________________
Subnet Mask ___________________________
Default Gateway ________________________
For assistance, contact your local Xerox Customer Support Center:
USA: 1-800-821-2797
Canada: 1-800-939-3769
Go to the printer and...
1.
Connect your Document Centre 460/470
to the network with the appropriate
cabling.
2.
Enter the Tools pathway.
a)
Press the Access ( ) button.
b)
On the keypad enter 1111 or the
current password. Press the Enter
button when finished. Press the Go to
Tools button.
c)
The Touch Screen will be used for the
remainder of the data entry.
3.
Enter the Network Setup menus
a)
Wait for the screen to refresh and
press the Connectivity and Network
Setup button.
b)
Wait for the screen to refresh and
press the Network Setup button.
c)
Press the TCP/IP Options button.
Page 1
4.
Enable the network interface and
protocol.
a)
Press the TCP/IP Settings button.
b)
Press the Protocol and Media button.
c)
Press the Enable button. If Physical
Media buttons appear, select either
Ethernet or Token Ring. Press Save.
5.
Set the Host Name
a)
Press the Host/Address button.
b)
One at a time press the soft buttons on
the Touch Screen for each octet of the
IP address and enter the numbers
using the keypad.
c)
Press the Host Name button.
d)
When the soft keypad appears, type
the host name EXACTLY as you want
it to appear with correct case. When
finished press the Save button to
record the changes and exit to the
TCP/IP Settings Screen.