CLARIUS EP PLUS VEP-CW10 Посібник з монтажу - Сторінка 3

Переглянути онлайн або завантажити pdf Посібник з монтажу для Прожектор CLARIUS EP PLUS VEP-CW10. CLARIUS EP PLUS VEP-CW10 6 сторінок. Led floodlight

The unit may have been ordered and supplied with an integrated photocell. Care should be taken

when positioning the unit to ensure the sensor is not shielded, is not pointing directly at another light

source and is monitoring the general, prevailing light conditions.

The mounting bracket for the Clarius EP Plus floodlight is packed separately in the carton. The bolts in

the side of the housing shall be removed and used to secure the bracket to the Clarius EP Plus

housing. It is very important that the red fibre washers are fitted between the Clarius EP Plus housing

and the mounting bracket. The unit must be aligned first before securing the bracket. The unit can

be mounted horizontally or vertically allowing the unit to point up/down or left/right, 2 additional

holes allow the bracket/fasteners to be moved to suit mounting application. An external eye bolt is

supplied to allow safety chains/suspension cords to be fitted if required.

POWER CONNECTIONS

Wire the Mains cable into the terminal block. Provision has been made for this and identified as the

E (Earth), L (Live) and N (Neutral) terminals. There are two pairs of contacts for each of these to

facilitate a mains cable that can be looped in and out of the unit.

The installer should earth the unit separately.

Connect wires to mains supply; Blue=neutral: Brown=Live: Green/Yellow=Earth

Isolate the unit before opening.

Tel: +44 (0) 1706 363 998