CLARIUS EP PLUS VEP-CW10 Посібник з монтажу - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник з монтажу для Прожектор CLARIUS EP PLUS VEP-CW10. CLARIUS EP PLUS VEP-CW10 6 сторінок. Led floodlight

Note: Torque = Newton Meter (Nm)

All Clarius EP Plus units have terminal blocks suitable for 4mm2 live, neutral and earth.

To maintain an IP rating of 66/67 All M6 socket head cap bolts fixing the

polycarbonate lid to the enclosure shall be tightened down to 2.5 Nm.

10.

When installing the unit the special conditions for safe use should be adhered to –

Except for internal wiring, not more than one single or multiple strand lead shall be

connected into either side of any terminal unless multiple conductors have been joined in

a suitable manner, e.g. two conductors into a single insulated crimped boot lace ferrule.

ii.

Leads connected to the terminals shall be insulated for the appropriate voltage and this

insulation shall extend to within 1 mm of the metal of the terminal throat.

iii.

When terminals in accordance with certificate Sira 01ATEX3247U are used, all terminal

screws, used and unused, shall be tightened down to between 0.5 Nm and 0.7 Nm.

iv.

When terminals in accordance with certificate Sira 01ATEX3249U are used, all terminal

screws, used and unused, shall be tightened down to between 1.2 Nm and 2 Nm.

When terminals in accordance with certificates Sira 01ATEX3247U and Sira 01ATEX3249U

are used, they shall only be installed and wired with cable within a temperature range of

-10°C to +80°C.

vi.

When cross-connecting combs are used on terminals to certificates Sira 01ATEX3247U and

Sira 01ATEX3249U, the relevant conditions certification associated with those certificates

shall be applied.

vii.

Cable entry holes shall be fitted with either an appropriately certified cable gland or

appropriately certified blanking element. These shall provide and maintain a minimum

enclosure ingress protection of IP66 or IP67 as appropriate.

viii.

If more than 8 individual LED's are not illuminated the LED assembly must be replaced.

ix.

When the optional fuse is not fitted, the supply circuit must be protected by a fuse capable

of withstanding a prospective short circuit current of 1500A

ADDITIONAL IMPORTANT INFORMATION