eControls WRC Посібник користувача - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник користувача для Пульт дистанційного керування eControls WRC. eControls WRC 2 сторінки. Wireless remote control for direct damper control

Друкувати сторінку

Selecting the Zone

Number

Press and release the SEL key and the LCD will show the

Zone number. Use the Up and Down keys to change the Zone

number, and press the ENT key. The new Zone number and

Airflow will be displayed. Zones or diffusers are numbered 1 to

32.

Selecting the Address

Number

Select a unique address number corresponding to the

department, floor or building. Press and release the SEL key

twice and the LCD will show the Address number. Use the Up

and Down keys to select the Address, and press the ENT key.

Setting the Damper Zone

and Home Address

The WCD Damper Actuator must be programmed to receive

the remote commands corresponding to the selected Zone

and Address numbers. After selecting the Zone and Address

numbers as previously described, press the small pushbutton

switch on the WCD Damper Actuator. The LED will alternately

blink red and green. During the next 30 seconds, the Zone and

Address can be programmed into the WCD Damper Actuator.

Press and release the SEL key three times until PRG DPR

appears in the lower left corner of the LCD. Press the ENT key

and the WCD Damper will be programmed with the Zone and

Address number.

ZONE

ADR

ZONE

PRG DPR

Adjusting Airflow

After selecting the Zone number, press the Up and Down keys

to set the Airflow. Pressing the ENT key sends the new Airflow

setting to the WCD Damper.

Low Battery Warning

When batteries are low, the display will show "Lob" and the

batteries should be changed. Lithium AAA batteries should be

used for longer life.

3-Year Limited Warranty

This is a "Limited Warranty" which gives you specif rights. You may

have other rights which vary from state to state.

For a period of three years from the date of purchase, any malfunction

caused by factory defective parts or workmanship will be corrected at

no cost to you. See the complete Warranty at eControlsUSA.com.

ZONE

AIRFLOW

ZONE

AIRFLOW

Remove battery cover

and install two AAA batteries

as shown.