Directed 403.CHRYSLER6 Посібник з монтажу - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник з монтажу для Автомобільні аксесуари Directed 403.CHRYSLER6. Directed 403.CHRYSLER6 20 сторінок.

Pre-installation and application warnings

Firmware notes: This section highlights important information for this specific firmware and will assist in

pricing accordingly, as well as bringing awareness to any operational or vehicle limitations.

T-Harness

compatible

The optional Plug & Play THCHD3 (Rev. 1 to 2) T-Harnesses are sold sparately.

The OBDII Diagnostic Connector features will remain the same even when the T-Harness is installed.

The keyless entry control on the OEM Key FOB used during Key2Go programming will not work while the vehicle is remote

started.

Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic

connector.

Refer to the "Vehicle connections" section following the wiring diagram.

General notes: This section highlights important information for this specific firmware.

The Tach wire is an optional connection required on some remote starters, which do not support a tach signal in D2D.

[1]

The RAP Off connection is ONLY required if NOT supported in data.

[2]

403.CHRYSLER6 2.14 2014 Dodge/Ram 3500

THCHD3 (Rev. 1 to 2)

Keys required for

programming

operation