Clarke CIWLI300 Інструкція з експлуатації та обслуговування - Сторінка 9
Переглянути онлайн або завантажити pdf Інструкція з експлуатації та обслуговування для Електроінструмент Clarke CIWLI300. Clarke CIWLI300 17 сторінок.
Друкувати сторінку
OPERATION
CAUTION: MAKE SURE THAT THE WRENCH IS FULLY OFF BEFORE
ATTACHING OR REMOVING A SOCKET. ALWAYS TAKE CARE TO USE THE
CORRECT SIZE SOCKET FOR BOLTS AND NUTS. AN INCORRECT SOCKET
WILL CAUSE DAMAGE TO THE BOLT OR NUT.
FITTING A SOCKET
1. Align the chosen socket and
simply push it onto the anvil. Use
only ½" square drive impact
sockets supplied, or as listed on
page 11.
2. Squeeze the trigger to start the
impact wrench. Release the
trigger to stop.
FORWARD/REVERSE SELECTION
1. Select the direction of operation by
pushing the selector bar in the
appropriate direction.
• The direction of rotation is shown on
the end face of the switch-bar.
• When the selector bar is in the central
position the trigger is locked.
2. Always check the direction of rotation
before operation.
LOOSENING A NUT
1. Fit the appropriate socket to the square
drive of the wrench.
2. With the FORWARD/NEUTRAL/REVERSE
switchbar in the REVERSE running position, and holding the wrench firmly in
BOTH HANDS, pull the trigger. The nut will be impacted repeatedly until it is
loosened. IMPORTANT! Release the trigger immediately the nut begins to
loosen.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
9