Zanussi DF47/51FF Інструкція із застосування та догляду - Сторінка 11
Переглянути онлайн або завантажити pdf Інструкція із застосування та догляду для Холодильник Zanussi DF47/51FF. Zanussi DF47/51FF 32 сторінки. Fridge freezer
Також для Zanussi DF47/51FF: Інструкція з використання та догляду (32 сторінок), Інструкція з використання Посібник з використання (32 сторінок)
Друкувати сторінку
Kl.KC .TRICAL CONNECTIONS
WARNING: THIS APPLIANCE
MUST BE EARTHED.
The manufacturer declines any liability should
this safety measure not be observed.
If the plug that is fitted to your appliance is not
suitable for your socket outlet, it must be cut off
and the appropriate plug fitted.
The cut off plug MUST be disposed of to
prevent the hazard of electric shock in case it
should be plugged into a 13amp socket in
another part of your home.
Important
The wires in the mains lead are coloured in
accordance with the following code:
Green and Yellow
- Earth
Blue
- Neutral
Brown
- Live
If you fit your own plug the colours of the wires
on the mains lead of your appliance may not
correspond with the markings identifying the
terminals in your plug. Proceed as follows, see
Fig. 7
Connect the green and yellow (earth) wire to the
terminal in the plug which is marked with the
letter 'E' or the earth symbol
or coloured
green and yellow.
Connect the blue (neutral) wire to the terminal
in the plug which is marked with the letter 'N'
or coloured black.
Connect the brown (live) wire to the terminal in
the plug which is marked with the letter 'L' or
coloured red.
The plug moulded onto the cord incorporates a
fuse, for replacement, use a 13amp BS1362
fuse. Only ASTA approved fuses should be
used.
The fuse cover/carrier is the one shown by the
coloured insert at the base of the plug.
The plug must not be used if the fuse
cover/carrier is lost. A replacement cover/carrier
must be obtained from your local Zanussi
Service Force Centre whose addresses are listed
on the pages at the back of this instruction book
and can also be found in the telephone directory
under 'Z'.
If at any time a replacement mains lead is
required, the cross sectional area of its
conductors must not be less than 0.75mm2.
If it becomes necessary to replace the mains
lead, the cable clamp should be tightened so as
to retain the new cord.
We recommend that the installation be checked
by a qualified electrician who can ensure that
the appliance is operating satisfactorily and that
it has not been damaged in transit.
This appliance complies with E.E.C. Directive
number 82/499 of 7.6.82 relative to radio
interference suppression.
10