Zanussi ZRD 27 JC Інструкція з експлуатації - Сторінка 10
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Холодильник Zanussi ZRD 27 JC. Zanussi ZRD 27 JC 18 сторінок. Refrigerator- freezer combination
GB
Technical data
Model
Gross capacity (l)
Net capacity (l)
Width (mm)
Height (mm)
Depth (mm)
Energy consumption (kWh/24h)
(kWh/year)
Energy class, according to EU standards
Freezing capacity (kg/24h)
Rising time (h)
Rated power (W)
Weight (kg)
Number of compressors
Installing the appliance
Transportation, unpacking
It is recommended to deliver the appliance in origi-
nal packaging, in vertical position considering the
protective warning on packaging.
After each transportation the appliance must not be
switched on for approx. 2 hours.
Unpack the appliance and check if there are damages on
it. Report possible damages immediately to the place you
bought it. In that case retain packaging.
Cleaning
Remove every adhesive tape, which ensure the parts not
to move in the appliance.
Wash the inside of the appliance using lukewarm water
and mild detergent. Use soft cloth.
After cleaning wipe out the inside of the appliance.
Placement
The ambient temperature has an effect on the energy con-
sumption and proper operation of the appliance. When
placing, take into consideration that it is practi- cal to oper-
ate the appliance between ambient tem- perature limits
according to the climate class that is given in the chart
below and can be found in the data label.
Class of climate
SN
N
ST
52
Instructions for the Installer
ZRD 27 JC
Freezer:
Refrigerator: 220
Freezer:
Refrigerator: 217
Ambient temperature
+10 ... +32 °C
+16 ... +32 °C
+18 ... + 38 °C
50
50
545
1590
604
0,82
299
A
4
20
90
55
1
If the ambient temperature goes below the lower data the
temperature of the cooling compartment can go beyond
the prescribed temperature.
If the ambient temperature goes beyond the upper data
this means longer operating time of the compressor,
breakdown in the automatic defrosting increasing temper-
ature in the cooling compartment or increasing energy
consumption.
When placing the appliance ensure that it stands level.
This can be achieved by two adjustable feet (1) at the bot-
tom in front.