Directed Security and Remote Start Посібник з монтажу - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник з монтажу для Автосигналізація Directed Security and Remote Start. Directed Security and Remote Start 20 сторінок. Security and remote start
Друкувати сторінкуAdjusting the Sensor
Important! Make sure the vehicle is disarmed. The shock sensor sensitivity can be adjusted by using a trimmer tool to turn the potentiometer.
Adjusting the sensor:
Disarm the system, turn the ignition Off.
1.
2.
With the sensor mounted in its permanent location, locate the trim pot on the shock sensor module and using a trimmer tool:
•
Turn the potentiometer clockwise for increased sensitivity or
•
Turn it counterclockwise for decreased sensitivity
Note: You can test the new setting by cautiously impacting the vehicle with increasing intensity while noting the LED status on the shock
sensor. The LED turns on for a short duration for small impacts before turning off (indicating a warn-away trigger). The impact level required
to fully trigger the alarm is indicated when the LED remains on for a longer duration before turning off.
Tachometer settings
Tach Learning
To learn the tach signal:
1.
Start the vehicle with the key.
2.
Within 5 seconds, press and hold the control center button.
3.
After 3 seconds the LED will light constant when the tach signal is learned.
4.
Release the control center button.
Important: This unit can learn the tachometer with the analog input or through D2D
using an interface module. The unit confirms which source is used.
When programming tach learning with:
•
Analog, the parking lights flash one time.
•
D2D interface module, the parking lights flash twice
If the tachometer input on the system is connected to the vehicle, the D2D tachometer input will be ignored.
Virtual Tach
Note: Virtual tach is not recommended for diesel trucks
To program Virtual Tach:
1.
After the install is complete, remote start the car.
2.
If the car does not start on the first attempt, let the remote start attempt again.
3.
Once the car starts, let it run until the parking lights come on.
4.
When the parking lights come on, shut off the remote start with the remote - that's it! Virtual Tach is programmed.
Virtual Tach handles disengaging the starter motor during remote starting – it does not address over-rev. If the customer wants to have the over-
rev protection capability, the tach wire must be connected. This may involve more installation shop charges than initially quoted.
Important: If the Virtual Tach mode over cranks or doesn't crank the vehicle long enough to start and run the
car, use the Bitwriter to add or subtract the starter output time. You can adjust the output time in increments
of 50msec of the learned time using the Bitwriter.
Programming jumpers
© 2012 Directed. All rights reserved.
7