Zanussi ZGG 78 Інструкція з експлуатації - Сторінка 5
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Варильна поверхня Zanussi ZGG 78. Zanussi ZGG 78 11 сторінок.
Друкувати сторінку
Instruction for the User
Hob burners control knobs
The symbols on the hob burners control knobs mean that:
there is no gas supply
there is maximum gas supply
there is minimum gas supply
Lighting the burners
For easier lighting, proceed before putting a
pan on the pan support.
To light a burner:
Push in the relevant knob and turn it anticlockwise
to "maximum position".
At the same time, keep the knob pushed down for
about 5 seconds. This will allow the "thermocouple"
(Fig. 1, lett. C) to be heated and the safety device
to be switched off, otherwise the gas supply would
be interrupted.
Then, check the flame is regular and adjust it as
required.
If you cannot light the flame even after several attempts,
check the "cap" (Fig. 1, lett. A) is in the correct position.
To put the flame out, turn the knob to the symbol .
Always turn the flame down or put it out
before taking the pans off the burner.
Using the hob correctly
To ensure maximum burner efficiency, it is strongly
recommended that you use only pots and pans with a
bottom fitting the size of the burner used, so that flame will
not spread beyond the bottom of the vessel (See table
beside).
It is also advisable, as soon as a liquid starts boiling, to
turn down the flame so that it will barely keep the liquid
simmering.
Use only pans or pots with flat bottom.
Carefully supervise cookings with fats or
oil, since these types of foodstuff can result
in a fire, if over-heated.
Fig. 1
A - Burner cap
B - Ignition candle
C - Thermocouple
D - Burner crown
Burner
Large (triple crown)
Medium (semi-rapid)
Small (auxiliary)
A
D
C
B
minimum
maximum
diameter
diameter
180 mm
260 mm
120 mm
220 mm
80 mm
160 mm
5