Zanussi ZGG 78 지침 책자 - 페이지 5

{카테고리_이름} Zanussi ZGG 78에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZGG 78 11 페이지.

페이지 인쇄

Instruction for the User

Hob burners control knobs

The symbols on the hob burners control knobs mean that:

there is no gas supply

there is maximum gas supply

there is minimum gas supply

Lighting the burners

For easier lighting, proceed before putting a

pan on the pan support.

To light a burner:

Push in the relevant knob and turn it anticlockwise

to "maximum position".

At the same time, keep the knob pushed down for

about 5 seconds. This will allow the "thermocouple"

(Fig. 1, lett. C) to be heated and the safety device

to be switched off, otherwise the gas supply would

be interrupted.

Then, check the flame is regular and adjust it as

required.

If you cannot light the flame even after several attempts,

check the "cap" (Fig. 1, lett. A) is in the correct position.

To put the flame out, turn the knob to the symbol .

Always turn the flame down or put it out

before taking the pans off the burner.

Using the hob correctly

To ensure maximum burner efficiency, it is strongly

recommended that you use only pots and pans with a

bottom fitting the size of the burner used, so that flame will

not spread beyond the bottom of the vessel (See table

beside).

It is also advisable, as soon as a liquid starts boiling, to

turn down the flame so that it will barely keep the liquid

simmering.

Use only pans or pots with flat bottom.

Carefully supervise cookings with fats or

oil, since these types of foodstuff can result

in a fire, if over-heated.

Fig. 1

A - Burner cap

B - Ignition candle

C - Thermocouple

D - Burner crown

Burner

Large (triple crown)

Medium (semi-rapid)

Small (auxiliary)

minimum

maximum

diameter

180 mm

260 mm

120 mm

220 mm

80 mm

160 mm