Zanussi ZUC 053W Інструкція з експлуатації - Сторінка 10

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Морозильна камера Zanussi ZUC 053W. Zanussi ZUC 053W 16 сторінок. Zanussi freezer instruction book
Також для Zanussi ZUC 053W: Специфікація (8 сторінок), Інструкція з експлуатації (16 сторінок)

Друкувати сторінку
If the appliance is not working correctly, please carry out the following checks before contacting your local Zanussi Service
Force Centre.
Problem
No power to the appliance
The temperature in the appli-
ance is too high
The temperature in the appli-
ance is too low
Excessive frost and ice has
built up
The appliance is noisy.
If after the above checks your appliance still does not
operate correctly, contact your local Zanussi Service
Force Centre.
Please note that it will be necessary to provide proof of
purchase for any in-guarantee service calls.
10

Something Not Working

Possible Cause
No power at the socket.
There is a power cut.
The fuse has blown.
Thermostat control is set at „0".
The appliance is located in an unsuitable
position.
The thermostat control is set too low.
The thermostat control is set too high.
The door has been left open.
Something is obstructing the door.
The door gasket is dirty.
The appliance is not level.
Check there is power at the socket.
Check there is not a power cut by
checking the household lights.
Check the fuse has not blown.
Check the thermostat setting.
Check the ambient temperature is with-
in the appliances operating limits of 16
°C to 32 °C.
Check that the thermostat control knob
is turned to the correct setting relative
to ambient conditions.
Set the thermostat control knob to a
lower position.
Check the door has not been left open.
Check nothing is preventing the door
from closing.
Check the door gasket is intact and
clean.
Check if the appliance stands stable
(all four feet should be on the floor).
In-guarantee customers should ensure that the
above checks have been made, as the engineer will
make a charge if the fault is not a mechanical or
electrical breakdown.
Solution