Zanussi ZUC 053W Інструкція з експлуатації - Сторінка 12

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Морозильна камера Zanussi ZUC 053W. Zanussi ZUC 053W 16 сторінок. Zanussi freezer instruction book
Також для Zanussi ZUC 053W: Специфікація (8 сторінок), Інструкція з експлуатації (16 сторінок)

Друкувати сторінку

Ventilation Requirements

The appliance must have adequate ventilation to ensure

correct operation.

Diagram shows the ventilation requirements when

installed:

A* Under a worktop, or cupboard.

The clearance space of 10 cm above the appliance

may be reduced to 5 cm providing a clearance space

2.5 cm is left on either side of the appliance.

When freestanding

Door Reversal

If required the opening direction of the door can be

changed as follows:

To reverse the hinge assembly proceed as follows:

Disconnect the appliance from the electricity supply.

Remove the top hinge cover.

Unscrew the 2 retaining screws, and remove the

hinge from the appliance.

Take the door off.

Remove the screw fixing the lower door holder and

the other screw fixing the lower door holder and the

foot. Then remove the door holder and the foot as

shown in the Figure.

Loosen the screw fixing the foot opposite the lower

door holder in order to remove the foot.

Fix the door holder and the corresponding foot on the

opposite side and then the other loosened foot at the

former place of the door holder as shown in the

Figure.

Please make sure to place the lower foot

below the door holder. The lower foot is

recognizable by its 4 ribs on the outer surface.

Fix the door onto the lower hinge pin.

To fit top door hinge, remove the plastic blanking

plugs carefully, and refit them in the holes left by the

hinge retaining screws.

Refit the top hinge using the 2 retaining screws, tak-

ing care that the edge of the door is parallel with side

of the cabinet.

Replace the hinge cover.

Remove screw covers (if fitted) and handle retaining

screws. Remove blanking plugs on the opposite side

using a punch.

Relocate the handle to the opposite side and refit

retaining screws (covers if fitted), and push the plas-

tic plugs supplied with the instruction book into the

holes where the handle was previously fitted.