Zanussi ZHC4284 Посібник користувача - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник користувача для Вентиляційна витяжка Zanussi ZHC4284. Zanussi ZHC4284 44 сторінки. Zanussi chimney hood product brochure
Також для Zanussi ZHC4284: Особливості (5 сторінок)

Друкувати сторінку

Before carrying out any maintenance or cleaning isolate the cooker hood from the mains supply.

Charcoal Filters

In the recirculation mode the charcoal filters absorb smells and unwanted odours.

Enabling the alarm signal

• In Recirculation version Hoods, the Filter saturation alarm can be enabled on installation or at a later date.

• Turn the Lights and the suction Motor off.

• Disconnect the Hood using the Main switch or the double-pole switch on the mains power supply.

• Restore the connection by pressing and holding T1.

• Release the button. All five LEDs are turned on

• Within 3 seconds press T1 until LEDs T1 and T4 flash in confirmation:

• LED flashes twice - Activated charcoal filter saturation alarm ENABLED

• LED flashes once - Activated charcoal filter saturation alarm DISABLED

The filter is not washable and cannot be regenerated. It must be replaced when led S1 flashes or at least every

4 months. The alarm signal will only light up when the extractor motor is switched on.

To Remove/Replace the Charcoal Filters

• Open the lighting unit by pulling on the notch.

• Remove the metal grease filters

• Remove the saturated activated carbon filter by

releasing the fixing hooks

• Fit the new filter by hooking it into its seating

• Replace the metal grease filters.

This appliance can be a possible fire

hazard if the grease and charcoal filters

are not cleaned and replaced as recommended.

Alarm signal reset

• Switch off the lights and extractor motor.

• Press button T3 for at least 3 seconds, until the

leds start to flash.

Changing the halogen light

• Remove the 2 screws fixing the Lighting support,

and pull it out of from the Hood.

• Extract the lamp from the Support.

• Replace with another of the same type, making sure

that the two pins are properly inserted in the lamp

holder socket holes.

• Replace the Support, fixing it in place with the two

screws removed as above.

Replacement filters and halogen light can be obtained from your local Service Force Centre.

MAINTENANCE AND CLEANING