Aleko Victoria Series Посібник з монтажу - Сторінка 19
Переглянути онлайн або завантажити pdf Посібник з монтажу для Аксесуари Aleko Victoria Series. Aleko Victoria Series 20 сторінок. Sizes 6.5x5 8x6.5 10x8
Також для Aleko Victoria Series: Інструкція з монтажу та експлуатації (12 сторінок), Посібник з монтажу (14 сторінок), Посібник з монтажу (17 сторінок)
- 1. Parts Diagram
- 2. Assembly Step One: Preparing Your Work Space
- 3. Assembly Step Four: Torsion Bar Assembly
- 4. Assembly Step Eight: Center Support Assembly
- 5. Installation: Notes about Wall Mounting
- 6. Optional Installation: Adjusting the Awning Pitch/Angle
- 7. Optional Installation: Motor Installation
NOTE: Each button must be pressed within four seconds of re-setting,
otherwise the system will restore to the original state.
1. Remove the back of the remote and insert the battery.
2. Plug your motor into a power outlet.
3. Press the P2 button two times. The motor will beep twice.
4. Press the up button one time. The motor will beep several times.
5. Press the up button one more time to activate the motor.
6. Your remote is now programmed.
STEP THREE: PROGRAMMING THE AWNING'S EXTENSION
POSITION
•
Press the up button once.
•
Use the regulator to adjust the awning's extension length by
inserting the green tool into the white plus sign hole, then rotate it.
•
When you have achieved your desired length, stop rotating and
press the stop button.
•
The extension limit is set.
STEP FOUR: PROGRAMMING THE AWNING'S RETRACTION
POSITION
•
Press the down button once.
•
Use the regulator to adjust the awning's retraction length by inserting
the green tool into the red minus sign hole, then rotate it.
•
When you have achieved your desired retraction position, stop
rotating and press the stop button.
•
The retraction limit is set.
+
P2 button
Up button
Stop button
Down button
-
Battery
19