Directed Electronics 100 ESP Посібник користувача - Сторінка 18
Переглянути онлайн або завантажити pdf Посібник користувача для Автосигналізація Directed Electronics 100 ESP. Directed Electronics 100 ESP 20 сторінок.
Друкувати сторінку
All manuals and user guides at all-guides.com
QUICK REFERENCE GUIDE:
To arm/lock using your remote
Pressing
for one second will arm the system and lock the doors.
The red LED will begin to flash once per second. The Failsafe® Starter
Kill will prevent the vehicle's starter from cranking if it has been in-
stalled. The vehicle's horn (if connected) will honk and the parking
lights will flash once to confirm arming of the system.
To disarm/unlock using your remote
To disarm the system and unlock the doors, press
The Failsafe® Starter Kill will be deactivated and the vehicle's horn (if
connected) will honk twice and the parking lights will flash twice.
Disabling the Failsafe® Starter Kill without a transmitter
To do this, you must have the vehicle's ignition key and know where the
Valet® switch is. Be sure to check with the installer for the location of
the Valet® switch. Turn on the ignition. Press and release the Valet®
switch, within 10 seconds. The LED will stop flashing and the vehicle
should start.
To enter or exit Valet
®
Mode
Turn the ignition to the "on" position. Turn the ignition back off. Press
and release the Valet® switch within 10 seconds. The Status LED will
light steady if you have entered Valet® Mode. To exit Valet® Mode,
repeat the steps above. The LED will turn off when exiting Valet® Mode.
To activate panic mode
Press and hold
down for 1.5 seconds.
To exit panic mode
Press
.
14
for one second.
1999 Directed Electronics, Inc.
©