Alemite 6713-4 Посібник з експлуатації - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Водяний насос Alemite 6713-4. Alemite 6713-4 10 сторінок. High-pressure bucket pump

Друкувати сторінку

SER 6713-4

Model Assembly

Refer to Figure 2-A for the assembly of the

components that are shipped loose.

Filling

The pump's container can be filled from a transfer

pump or manually.

NOTE: The three steps that follow consider

the pump without a follower plate.

Transfer Pump Loading

NOTE: Refer to Figure 2-A for component

identification on the following procedures.

1. Slide the fill-hole cover away from the pump.

2. Insert the hose from the transfer pump into the

opening.

• Make sure the hose reaches the bottom of Container

Assembly (7) or the surface of the product.

IMPORTANT: Keep the end of the hose (or

wand) just underneath the surface of the

grease. This prevents air from mixing with

the product during the fill process.

3. Fill the Container within 2-inches (5 cm) from the top.

Manual Loading (Paddle)

4. Loosen Knobs (3) from the bolts on Container

Assembly (7).

• Swing the bolts away from Cover Assembly (9).

CAUTION

Point the bottom of the pump tube upward. Pre-

vent contamination from foreign material. Damage

to components can occur.

5. Remove the cover and pump assembly from the

Container Assembly.

6. Fill the Container within 2-inches (5 cm) from the top.

• Do not allow air to be entrapped during the filling

process.

7. Place the optional follower plate onto the top of the

product.

• With a wobbling motion, eliminate any air that may

be trapped underneath the follower. Force the

product through the hole in the center of the plate.

Revision (2-02)

8. Position the cover and pump tube assembly into the

follower plate and fit the Cover onto the Container.

9. Secure the Cover to the Container with the Knobs.

Operation

WARNING

Do not exceed the lowest pressure rating of

any component in the system.

Ensure all components are in operable condition.

Replace any suspect parts prior to operation.

Personal injury can occur.

Priming the Pump

NOTE: Refer to Figure 2-B for component

identification on the following procedures.

1. Turn Bleed Valve Screw (26) counterclockwise to open.

2. Make sure Pressure-Relief Valve Screw (29) is closed.

3. Cycle the Lever until product causes the cycling of the

Lever to stiffen.

If the pump assembly does not prime, refer to the

Troubleshooting Chart for details.

4. Close the Bleed Valve Screw until it seats.

Dispensing

5. Wipe the end of the coupler and the fitting to be

lubricated with a clean cloth.

6. Attach the coupler to the lubrication fitting.

7. Operate the lever until the proper amount of lubricant is

dispensed.

NOTE: Certain applications can create exces-

sive back-pressure at the fitting that inhibits

the removal of the coupler. Should this occur:

8. Turn Pressure-Relief Valve Screw (29)

counterclockwise to open.

• This allows the product within the delivery hose to

return to the Container.

9. Remove the coupler from the fitting and close the

Pressure-Relief Valve Screw.

NOTE: Should the Lever be stopped in the

upward position:

10. Turn Bleed Valve Screw (26) counterclockwise to open.

• This allows the Lever to be pushed downward without

product discharge.

High-Pressure Bucket Pump

Alemite Corporation