Clarke CWBP300 Інструкція з експлуатації та технічного обслуговування - Сторінка 6
Переглянути онлайн або завантажити pdf Інструкція з експлуатації та технічного обслуговування для Водяний насос Clarke CWBP300. Clarke CWBP300 13 сторінок. Submersible water butt pump
Друкувати сторінку
USING THE PUMP
WARNING: CHECK THE PUMP FOR DAMAGE BEFORE USE, DO NOT USE THE
PUMP IF IT IS DAMAGED IN ANY WAY.
WARNING: THE WATER BEING PUMPED WILL BE POLLUTED IF THIS PUMP
BECOMES DAMAGED AND ANY LUBRICANT WITHIN THE PUMP ESCAPES.
1. Switch the mains power supply on.
• The pump will begin to discharge water.
• As the water level falls, so will the float switch until it stops the pump.
2. When pumping is finished, disconnect the pump from the power supply.
IMPORTANT: Do not allow the pump to run dry.
MAINTENANCE
WARNING: BEFORE CHECKING THE CONDITION OF THE PUMP, ENSURE IT
IS UNPLUGGED FROM THE POWER SUPPLY.
This pump should require no maintenance other than regular cleaning.
CLEANING
1. Check the pump installation
regularly to ensure the water inlet
is clear of leaves or other debris.
2. Twist and lift out the bottom cover
before removing the sponge filter.
Clean out the cavity and remove
any debris.
NOTE: Do not attempt to repair the
pump yourself as you may
damage the waterproof seal
and invalidate your guarantee. Therefore we recommend you contact
your CLARKE dealer or the CLARKE Service Department.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
6