Clarke CWBP300 운영 및 유지보수 지침 매뉴얼 - 페이지 6

{카테고리_이름} Clarke CWBP300에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CWBP300 13 페이지. Submersible water butt pump

USING THE PUMP

WARNING: CHECK THE PUMP FOR DAMAGE BEFORE USE, DO NOT USE THE

PUMP IF IT IS DAMAGED IN ANY WAY.

WARNING: THE WATER BEING PUMPED WILL BE POLLUTED IF THIS PUMP

BECOMES DAMAGED AND ANY LUBRICANT WITHIN THE PUMP ESCAPES.

1. Switch the mains power supply on.

• The pump will begin to discharge water.

• As the water level falls, so will the float switch until it stops the pump.

2. When pumping is finished, disconnect the pump from the power supply.

IMPORTANT: Do not allow the pump to run dry.

WARNING: BEFORE CHECKING THE CONDITION OF THE PUMP, ENSURE IT

IS UNPLUGGED FROM THE POWER SUPPLY.

This pump should require no maintenance other than regular cleaning.

CLEANING

1. Check the pump installation

regularly to ensure the water inlet

is clear of leaves or other debris.

2. Twist and lift out the bottom cover

before removing the sponge filter.

Clean out the cavity and remove

any debris.

NOTE: Do not attempt to repair the

pump yourself as you may

damage the waterproof seal

and invalidate your guarantee. Therefore we recommend you contact

your CLARKE dealer or the CLARKE Service Department.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]