Clarke CWBP300 운영 및 유지보수 지침 매뉴얼 - 페이지 5

{카테고리_이름} Clarke CWBP300에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CWBP300 13 페이지. Submersible water butt pump

PREPARATION

Remove all packaging and make sure that the product has no visible

damage. Dispose of all packaging appropriately.

ATTACHING THE TUBE AND HOSE

1. Screw the discharge tube/elbow

onto the outlet port as shown.

2. Connect a suitable garden hose

(not supplied) to the hose

connector.

• Suitable hoses are available

from your local Clarke dealer.

POSITIONING THE PUMP

1. Lower the pump into the water

butt with the outlet elbow over

the side of the water butt.

• Ensure the pump is positioned

with adequate space so that

the movement of the float

switch is not restricted -

recommended minimum area

of 50 x 50 cm.

2. Connect the plug to the mains

supply.

• Always use a high sensitivity

residual current device (RCD)

which has a tripping current of

30mA.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]