Directed Electronics Xpresskit DBALL Посібник з монтажу - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник з монтажу для Автомобільні аксесуари Directed Electronics Xpresskit DBALL. Directed Electronics Xpresskit DBALL 14 сторінок. Databus all combo bypass module
Також для Directed Electronics Xpresskit DBALL: Посібник з монтажу (14 сторінок)
Друкувати сторінку
Platform: DBALL/DBALL2
Firmware: GM5 Remote Start Ready (RSR) Installation
Feature and Option List
It is recommended to configure all the features and options listed below using the configuration tool found on the module
flashing page on www.directechs.com. The web offers more options; however, manual configuration of the features is possible
using the information on this page.
* Default Option
Feat.
Operation
1
RFTD Output Type
2
Unlock Driver Priority
3
Trunk
4
AUX1
5
AUX2
Smart OEM Alarm
6
Control
Flashes/Options
1. No RF Output*
Module is connected to a remote starter using a standard installation.
2. RFTD Output
Module is connected to an XL202 using an RSR or RXT installation (when available).
3. SmartStart
Module is connected to SmartStart using an RSR or RXT installation (when available).
Unlocks only the driver door on first press and unlocks all doors on a second press
1. Driver Priority*
within 5 seconds.
2. Unlock All Doors
Unlocks all doors on first press.
1. Trunk*
Will pop the trunk if available.
2. Right Sliding Door
When available, will operate the right sliding door.
2. Left Sliding Door
When available, will operate the left sliding door.
1. Trunk
Will pop the trunk if available.
2. Right Sliding Door*
When available, will operate the right sliding door.
2. Left Sliding Door
When available, will operate the left sliding door.
1. Trunk
Will pop the trunk if available.
2. Right Sliding Door
When available, will operate the right sliding door.
2. Left Sliding Door*
When available, will operate the left sliding door.
The OEM alarm will not be controlled by DBALL upon remote start. No disarm or arm
1. Disabled
command will be executed at the beginning or end of the sequence; it must be controlled
by the Remote Starter.
Smart OEM Alarm Control will behave like a standard Safelock feature on a remote
2. Safelock
starter. It will unlock at the beginning of the sequence, and relock after start and
shutdown.
Smart OEM Alarm Control will synchronize with the OEM alarm so that it will disarm and
rearm the vehicle in the remote start sequence, only when required. The reason for this
is, factory alarm control must often be done by lock or unlock operation. This could
create unnecessary actions on door lock modules, such as the horn to honk. When
possible, Smart OEM Alarm Control will monitor the alarm and door lock status to detect
3. Enabled*
if the disarm or rearm is required. If the vehicle is unlocked or is not equipped with factory
alarm, the disarm/rearm will not be executed. Smart OEM Alarm Control will also
monitor the remote starter actions so that the factory alarm control is not done twice. A
remote starter, for which the Safelock feature is active, will work perfectly with this option
and will make it invisible to the user.
Description
© 2015 Directed. All rights reserved.
Rev.: 20150626
Page 7