Afterglow FW-CTGSQFP Посібник - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник для Камін на відкритому повітрі Afterglow FW-CTGSQFP. Afterglow FW-CTGSQFP 17 сторінок. Cottage 34 in square gas fire pit

Друкувати сторінку

7. Un-screw the Handle Assembly (O), attach the Handle to the Door (D) using the phillips screw driver, then

screw it tightly (see Figure 7).

NOTE: DO NOT tighten the screws completely.

8. Attach the assembled base to the Table Top Assembly (A) with Bolt (AA) and Washer (BB) using the Hex Screw

Driver (CC). Make sure the control panel just covers up the notch on the Right Panel (B), (see Figure8). Then

tighten all the screws completely.

NOTE: DO NOT tighten the screws completely.

Hardware Used:

AA Bolt (M6 x 15)

BB Washer (M6)

CC Hex screw driver

FOR YOUR SAFETY: Surfaces of fire pit can remain extremely hot for

a period after use. Allow 45 minutes to cool down before touching or

moving the fire pit.

9. Put the Lava Rock (P) around the burner, then remove the label from the pilot box (see Figure 9). A gas fire pit

requires 13.2 lbs lava rock. NOTE: DO NOT completely cover the burner element or block the pilot box

with the lava rocks. When the first use, preheat the lava rocks for 15 minutes to burn out the impurities

and air in the natural lava rocks.

WARNING: keep children away during assembly, as this item contains lava rock, which are small pieces and

can be swallowed by children.

x 4

x 1

pilot box

Figure 7

Figure 8

Figure 9