CLAS OM 9381 Посібник - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник для Інструменти CLAS OM 9381. CLAS OM 9381 12 сторінок. Hgv silent-block puller/installation set

CLAS OM 9381 Посібник
OM 9381
HGV SILENT-BLOCK PULLER/INSTALLATION SET
INTRODUCTION
Please read this manual before carrying out any operation.
It is compulsory to read this instruction manual before starting any kind of action.
The proper operation and full compliance of this product's performance is guaranteed only if all the instructions
provided in this manual are closely adhered to.
Use protective work gloves, protective footwear, hard hat and safety goggles.
Misuse:
• This product should only be used as described in this documentation; any other use is considered improper.
• The manufacturer accepts no responsibility for any damage caused by the incorrect or unreasonable use of the
equipment.
• Moreover, misuse shall also void the warranty.
Take care of your tools:
• Be sure to store your tools in a clean state.
•Place the tools inside their original package.
Before use, it is advisable to check the completeness of the supply and for any transport damage.
Field of application
The tool kit described in these instructions is to be used to properly remove and re t the rubber-metal suspension
bushings with lateral slot (spring bushings). With the help of the special clamp provided with the tool set and
relating semirings, the suspension bushings are pre-tensioned gently to allow for their safe and easy insertion into
their seats, directly on the vehicle's component. In addition, using the accessories in the kit, you can also remove
the old bushings.
The tools can be used directly on the vehicle without the strenuous removal of the vehicle's entire components.
Support ring can also be adapted to use on the workshop press.
This kit contains a wide choice of tools for the most common uses, covering a wide range of heavy vehicles on the
market. Other semiring kits will be available on request.
Due to the necessary forces, especially during disassembly, it is advisable to use a hydraulic cylinder. The hydraulic
cylinder OH 3512 can be used.