Nikon D90 - Digital Camera SLR Посібник користувача - Сторінка 16

Переглянути онлайн або завантажити pdf Посібник користувача для Аксесуари для фотоапаратів Nikon D90 - Digital Camera SLR. Nikon D90 - Digital Camera SLR 26 сторінок. Focal digital camera
Також для Nikon D90 - Digital Camera SLR: Брошура та технічні характеристики (9 сторінок), Посібник з експлуатації (20 сторінок), Технічні характеристики (2 сторінок), Контрольний список та інструкція з експлуатації (25 сторінок), Посібник (28 сторінок), Як зробити (6 сторінок), Посібники (30 сторінок)

SW1 Switchboard

J1 connecter - Manual mode

the digital data of modern cameras is incompatible with conventional TTL

strobes and as 'old style' strobes might use a tension that is too high for

modern cameras and might damage the camera circuitry.

J1 connecter - iTTL or eTTL mode

as the strobes will need all the data on all the lines. Please note that in this

case only one strobe can be connected to the housing as most of these

strobe systems require a master and slave strobe. The master strobe will

be connected to the housing while the slave strobe will be connected to the

master strobe. In case Canon eTTL strobes are used, all 6 lines are required

and a 6-pin strobe connection needs to be installed on the housing.

J1 connecter - iTTL or eTTL mode + Manual mode

eTTL compatible strobe on SW1 have to switched on while all the connec-

tors of the non iTTL or eTTL compatible strobe have to switched off.

Hugyfot Housing for

SW1 Switchboard: 1 = Q signal on J4 connecter

When the camera hot shoe is connected to J1 and

when strobes are used in manual mode we strongly

recommend that all the switches on SW1 are turned

off. In this case only X and ground will be used as

When the camera hot shoe is connected to J1 and

when fully iTTL or eTTL compatible strobes are used

(e.g. Nikon SB 800, Canon 580 EX, Subtronic dttl,

...) all the switches on SW1 have to be switched on

When the camera hot shoe is connected to J1 and

when 1 fully iTTL or eTTL compatible strobe is used

in combination with 1 non iTTL or eTTL compatible

strobe, then all the connectors of the fully iTTL or

Nikon D90

2 = Q signal on J3 connecter

3 = SP signal on J4 connecter

4 = SP signal on J3 connecter

5 = RDY signal on J4 connecter

6 = RDY signal on J3 connecter

User manual