Dirt Devil DDCW600 Посібник користувача - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник користувача для Пилосос Dirt Devil DDCW600. Dirt Devil DDCW600 12 сторінок.

---

Maintenance

Replacing the dirty water tank

Lift the front of the carpet cleaner

base off the carpet with one hand.

Belt or brush removal and replacement

Phillips screwdriver required

The plug must be removed from socket outlet before cleaning or maintaining the appliance.

Switch off the mains power and

unplug carpet washer. Remove the

water tank.

Flip the cleaner on it's side to

expose the nozzle base.

dirtdevil.com.au

(Keep your Dirt Devil as good as new)

Grasp the handle and hook the front

of the dirty water cleaner into the

base, making sure that the front of the

dirty water tank is resting on the base.

The dirty water tank has three tabs on

the underside which MUST latch on

to the underside of the base of the

cleaner. The base must be lifted so

that the nozzle is flush with the base

of the cleaner.

Failure to install the dirty water tank

correctly will result in poor dirty water

pick up.

To remove the belt cover, use a

phillips screwdriver to remove the

two screws.

While making sure the dirty water

tank is resting on the base, place the

rear of the tank into the base of the

cleaner, push down on the handle

until it latches.

Empty and rinse clean water tank

after use.

Grasp the belt cover near the belt

roll and lift out.