Disaster Area Designs Qconnect Посібник користувача - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник користувача для Обладнання для запису Disaster Area Designs Qconnect. Disaster Area Designs Qconnect 16 сторінок. Multi output midi controller

Друкувати сторінку
s
m
etup
All of the configuration and customization options are contained within the Setup Menu. Any
changes you make in this menu are saved in the memory of the qCONNECT for future use.
Throughout this manual we'll indicate Setup Menu options as MENU = OPTION, meaning we'd
like you to navigate to that item in the Setup Menu and set its value to match.
NAVIGATING THE MENU:
SETU
HOLD TO
ENTER
Hold the left footswitch at
power-on to enter Setup.
Release the button when you
see SETUP on the display.
SETUP MENU ITEMS:
As you move through the menu you'll see the following items to edit. Feel free to tweak the
settings to your satisfaction, but if you're not sure about anything we recommend the default
settings as listed.
PRST: Number of presets available in Preset mode. If PRST is set to OFF, preset mode will be
disabled. Range OFF to 99, default 16.
DEV: Number of available device modes. The qCONNECT will scroll through the available
modes and then return to preset mode. Range OFF to DevJ, default DevH.
DEV.A
DEV.F
DEV.B
DEV.G
DEV.C
DEV.H
DEV.D
DEV.J
DEV.E
CFG.A
CFG.D
CFG.B
CFG.E
CFG.C
CFG.F
CFG.X
Configure the X and Y control ports.
CFG.Y
MID.T, MID.R, MID.B send MIDI on tip, ring, or both
EXP interfaces with expression pedal
TAP interfaces with tap tempo footswitch
MD.io sends and receives MIDI on same jack
Port X works with Meris and Alexander for Sysex Dumps
Port Y works with micro.clock for MIDI clock distribution
2
enu
HOLD TO
EDIT
Tap left or right to choose an
item to edit.
Hold left to edit the item, then
tap left or right to change its
value.
Hold left to return to the main
menu.
Device mode assignments. Select the device type assigned
to each channel of the controller to automatically set up the
correct MIDI commands for each device.
Note: There is no "DEV I" since I and 1 look very similar on the display
Configuration for the 6 main control ports, A-F.
TIP, RING, or BOTH sets which jack contacts transmit MIDI data.
Chase Bliss uses RING, most other devices use TIP
Select BOTH to use a y-cable on this port to feed two devices.
Defaults to RING.
PRE
TAP TO
MOVE
SAVE
HOLD TO
Hold the right footswitch to
save the settings and exit.
If you have changed any of the
port configurations, be sure to
power-cycle the qCONNECT.
SAVE