Cub Cadet 190-341-100 Інструкція з монтажу та обслуговування - Сторінка 6

Переглянути онлайн або завантажити pdf Інструкція з монтажу та обслуговування для Снігоочисник Cub Cadet 190-341-100. Cub Cadet 190-341-100 20 сторінок. 42" snow thrower attachment for cub cadet series 2000/2500 tractors
Також для Cub Cadet 190-341-100: Посібник оператора (20 сторінок)

Друкувати сторінку

Cub Cadet 190-341-100 Інструкція з монтажу та обслуговування

This section will familiarize you with the components of the Model 190-341 — 42" Snow Thrower Attachment.

Select a firm level surface that is large enough to accommodate both the snow thrower assembly and the tractor.

Remove the upper crating material, and remove the hardware pack from the shipping crate. Carefully roll the snow

thrower assembly rearward so that it rests on its bottom; then carefully "walk" the snow thrower off the shipping pal-

let. When repositioning the snow thrower, use care not to pinch or bind the chute crank support tube and/or lift han-

dle (B and C, Figure 1). Cut the tie strap and remove the packaging material from the chute crank support tube

assembly (B) and position to the left side of the snow thrower assembly. Cut the tie strap and remove the packaging

material from the lift handle assembly (C) and position to the right side of the snow thrower. Refer to Figures 1 and

2 to confirm that all parts are present and to acquaint yourself with the part descriptions. Throughout this manual's

instructions, the parts shown in Figures 1 and 2 will be identified by name, followed by either their callout letter or

number in parenthesis to aid in assembly and installation.

NOTE: Because different PTO clutch assemblies are used on the various Series 2000 tractor models, two PTO drive

belts are provided with the 341 Snow Thrower. If your tractor has a single cylinder engine, use the 754-

0441 (shorter) V-belt. If your tractor has a twin cylinder engine, use the 754-3075 (longer) V-belt.

REF.

NO.

SECTION I. INTRODUCTION

PART

NO.

N/A

Snow Thrower /Discharge Chute Assembly

N/A

Chute Crank/Tilt and Support Assembly

N/A

Lift Handle/Latch Release Cable Assembly

754-0441 PTO Belt, Type A; 76.1 Lg- For Single Cylinder Engines

754-3075 PTO Belt, Type B; 78.3 Lg - For Twin Cylinder Engines

Figure 1

DESCRIPTION

QTY.