Aercus WS2083 Посібник користувача - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник користувача для Метеостанція Aercus WS2083. Aercus WS2083 18 сторінок. Professional wireless weather station with usb upload

Друкувати сторінку

Important Notes

System Start

Insert two LR6 (AA size) batteries into the transmitter. The LED located in the middle on the front of the

transmitter will illuminate for 4 seconds then go off. The transmitter will make an initial data transmission

and then start the radio controlled time reception routine. If the time signal can be detected correctly the

LED will flash 5 times and then remain on for 20s, indicating the time signal has been found correctly (note no

time signal is available in Aus/NZ). When reception of the time signal is not possible the transmitter will

terminate radio controlled time reception after no more than five minutes and resume normal transmission.

During the radio controlled time reception period there is no transmission of the outdoor weather data to the

console.

Insert two LR6 (AA size) batteries into the Base Station. The console will illuminate for a few seconds with all

the display segments illuminated for checking. After this the Base Station will make an initial measurement

and start to register the transmitter (the Outdoor Reception Signal icon will be turned on). Do not touch the

Base Station before the outdoor data is received or the outdoor sensor learning mode will be terminated.

When the outdoor transmitter has been registered the Base Station will automatically switch to the normal

display mode from which all further settings can be adjusted by the user.

If no radio controlled clock (RCC) signal is detected during the initial setup, the transmitter will try once every

hour to get the RCC signal until a signal is received. Once the transmitter receives the RCC signal it will

transmit the signal to the Base Station which will display the Radio Controlled Clock icon and the time will

synchronise to the RCC time. If the Base Station does not receive the RCC signal or loses the signal the RCC

icon will not be displayed.

Positioning

Once you have verified that all of the components of the weather station are working they can be positioned

in their permanent places. Before permanently mounting make sure that all the components work properly

together at their chosen mounting or standing locations. If there appear to be problems with the 433 MHz

radio transmission they can mostly be overcome by moving the mounting locations.

Note: The radio communication between the receiver and transmitter in an open field can reach a distance of

up to 100m providing that there are no interfering obstacles such as buildings, trees, vehicles, high

voltage lines, etc. Radio interferences such as PC screens, radios or TV sets, can in bad cases entirely

cut off radio communication. Please take this into consideration when choosing standing or mounting

locations.

Reconnecting Lost Signal

If no outdoor weather data is displayed as a result of loss of signal during set up, mounting, changing of

batteries in the transmitter or plugging or unplugging cables, simply press and hold the DOWN key for 4

seconds then release. After this the Base Station will make an initial measurement and start to register the

transmitter (the Outdoor Reception Signal icon will be turned on). Do not touch the Base Station before the

outdoor data is received (this may take several minutes) or the outdoor sensor learning mode will be

terminated. When the outdoor transmitter has been registered the Base Station will automatically switch to

the normal display mode from which all further settings can be adjusted by the user.

Note: When replacing batteries in the transmitter wait two minutes before re-inserting for a proper reset.

Wind Direction

On the edge of the wind direction sensor, there are four letters - "N", "E", "S" and "W" representing the

directions North, East, South and West. The wind direction sensor has to be adjusted so that the directions on

the sensor are matching your real location. A permanent wind direction error will be introduced when the

WS2083

- 4 -