3D Hobby Shop 49 Sukhoi 26MX Посібник з монтажу - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник з монтажу для Іграшка 3D Hobby Shop 49 Sukhoi 26MX. 3D Hobby Shop 49 Sukhoi 26MX 18 сторінок.

Install wings without ailerons onto fuselage using carbon wing tube. NOTE – tube is packed in its travel

sleeve inside one wing bag. Install horizontal stabilizer into its slot as shown, align it side-to-side as

well as equalizing measurement from stab tips to wingtips as shown with tape measure. When stabilizer

is perfectly aligned, apply thin CA glue to the stabilizer–to-fuselage joint and allow to dry. Turn fuselage

over and apply thin CA glue to the bottom of the joint as well. If the gap between the stabilizer and

fuselage is not tight enough for thin CA glue to work well, follow up with medium or thick CA.

Install right side elevator, joiner will stick through as shown. Flex elevator to make sure you can get at

least 45 degrees throw, up and down. Use two drops of thin CA on each hinge.

Apply tape to the right side elevator balance as shown to hold the elevator perfectly straight.