3D Hobby Shop YAK55 Посібник з монтажу - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник з монтажу для Іграшка 3D Hobby Shop YAK55. 3D Hobby Shop YAK55 19 сторінок.
Друкувати сторінку-- Next place a small piece of tape on the elevator and stab as shown to hold the elevator perfectly straight and level to
the stabilizer.
-- Now install the other side elevator without glue. Make sure that the elevator is straight and level to the stabilizer like
the first elevator. If not, if the elevator shows a slight twist, you can take a little time and sand or trim the slot that the
elevator joiner rod fits into to correct this. A slight twist in the elevators will not affect flight performance, but it may
bother you, so this is the right time to correct it if necessary.
-- Once you are satisfied with the alignment of the elevator, remove it and put thick CA glue in the joiner slot as shown.
Re-install it onto the stab and joiner rod, and put two drops of thin CA glue on each hinge.