3D Hobby Shop YAK55 Посібник з монтажу - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник з монтажу для Іграшка 3D Hobby Shop YAK55. 3D Hobby Shop YAK55 19 сторінок.

-- Making sure to slide the cowling underneath the taped pieces of paper, slide the cowling onto the front of the plane as

shown below.

-- Holding the cowling in place with tape, take your time to align the cowling on the fuselage. Measure vertically and

horizontally from the edge of the front of the cowling to the motor to ensure that the cowling is centered as shown.

-- When the cowling is aligned and centered, using a hobby knife or fine drill, start the holes in the cowling to the

locations indicated by the pieces of paper. Install the wood screws.

-- Remove the cowling, and soak the newly created cowling screw holes with thin CA and allow to cure to strengthen the

cowling mounts.

-- Remove the tape from the canopy hatch and sides of the fuselage and reinstall the cowling. Everything should align

properly and the canopy hatch fitting nicely under the cowling.

-- On the base of the rudder, using a sharp knife open the covering the slot for the tail wheel wire. Add some thick CA to

the slot and insert the wire as shown below.