3D Shape Engineering Motorized Camera Slider v1 Документація та втручання - Сторінка 3

Переглянути онлайн або завантажити pdf Документація та втручання для Аксесуари для фотоапаратів 3D Shape Engineering Motorized Camera Slider v1. 3D Shape Engineering Motorized Camera Slider v1 7 сторінок.

Друкувати сторінку

3D Shape Engineering Motorized Camera Slider

Documentation & Instructions

The motor connects to a port on the inside of the electronics module. The

connection is labeled STEPPER CONN and is on the opposite end of the opening for

the motor wire.

The electronics module is easily removable so you can change settings without

disturbing the slider. The electronics module arm has a cable holder for the motor

cable. Make sure the motor cable does not come in contact with the wheels of the

slider plate.

Powering The Camera Slider Electronics Module

The electronics module currently supports the use of (2) 18650 3.7v batteries. Insert

the batteries into the caddy, making sure to pay attention to the + and - signs on one

of the ends. Align the ends of the batteries up to the line near the + and - markings

and insert the caddy into the electronics box when you are ready to use the slider.

When the slider is not being used, please remove the battery caddy and place the

Battery Protection Case over the Battery Caddy.

3dshapeengineering.com