3D Shape Engineering Motorized Camera Slider v1 Documentation & Instrusctions - Page 3

Browse online or download pdf Documentation & Instrusctions for Camera Accessories 3D Shape Engineering Motorized Camera Slider v1. 3D Shape Engineering Motorized Camera Slider v1 7 pages.

 
3D Shape Engineering Motorized Camera Slider 
Documentation & Instructions 
The motor connects to a port on the inside of the electronics module. The 
connection is labeled STEPPER CONN and is on the opposite end of the opening for 
the motor wire. 
 
 
 
The electronics module is easily removable so you can change settings without 
disturbing the slider. The electronics module arm has a cable holder for the motor 
cable. Make sure the motor cable does not come in contact with the wheels of the 
slider plate. 
 
Powering The Camera Slider Electronics Module 
The electronics module currently supports the use of (2) 18650 3.7v batteries. Insert 
the batteries into the caddy, making sure to pay attention to the + and - signs on one 
of the ends. Align the ends of the batteries up to the line near the + and - markings 
and insert the caddy into the electronics box when you are ready to use the slider. 
When the slider is not being used, please remove the battery caddy and place the 
Battery Protection Case over the Battery Caddy. 
 
©2018 3D Shape Engineering 
3dshapeengineering.com