3Disc Heron IOS Посібник із швидкого старту - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Стоматологічне обладнання 3Disc Heron IOS. 3Disc Heron IOS 12 сторінок.

Scanning Step 3: Basic Scanning Procedure

1. Place the open end of the tip of the heron over the area of interest, and keep it

stationary.

2. Click the scan button (A)

once in QuantorClinic, or

press the main button

on the handpiece.

3. Keep the handpiece

stationary over the

object of interest until

you hear a clicking sound

(if there is no clicking,

please adjust the sound

settings on your computer). You should see a 3D surface in the model view

window, with a green rectangle which indicates the last scanned position (B).

4. Continue scanning by moving the scanner slowly over and around the area

of interest. The Heron IOS can scan at a range of 0 to 12mm, however, better

scans are obtained at a closer range, and it is okay if the tip touches the

teeth. During scanning, you should continue to hear a rapid clicking sound and

observe a green rectangle indicating the last scanned area.

5. If the clicking sound

stops and a red rectangle

is visible on the model,

this indicates that data

from the handpiece is no

longer being integrated

into the model. In order

to continue scanning,

place the handpiece

over any area that

you have previously

scanned. When new data is being added to the model, the red rectangle

will change to green, the clicking sound will resume, and you can continue

scanning.

6. The scan can be paused by pressing the scan button on the handpiece, or

the scan button (A) in QuantorClinic. It is recommended to inspect the 3D

model, as it may be necessary to re-scan certain areas in order to fill in gaps, or

improve the scan quality.