3Doodler Create+ Посібник користувача - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник користувача для Аксесуари 3Doodler Create+. 3Doodler Create+ 11 сторінок.
Також для 3Doodler Create+: Посібник користувача (16 сторінок)
Друкувати сторінку
STEP 4:
Doodle Even More!
Here's everything you need to know about swapping filament
strands to change colors or filament type.
STEP 5:
Reverse and
remove plastic
02/2022
Your Name:
#MyFirstDoodle
For further guides, projects and inspiration, please refer to:
•
learn.the3doodler.com/resources/
•
learn.the3doodler.com/getting-started/
•
learn.the3doodler.com/help/
1
GREEN
Light
With the pen set to PLA, wait
for the
GREEN
light to come
on.
TIP
SNIP THOSE ENDS!
After removing a plastic strand from the 3Doodler Create+,
cut and dispose of any partially melted material at the end of
your strand. This will reduce blockages and clogging issues.
2
Flashing
GREEN
x2
Double click either speed
button. The LED light will flash
to signal plastic is reversing.
SECTION 2: GETTING STARTED
3
Once Plastic stops reversing, it is
safe to remove it from the pen
by gently pulling on the back of
the strand.
4
EN