3Doodler Create+ 사용자 설명서 - 페이지 4

{카테고리_이름} 3Doodler Create+에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3Doodler Create+ 11 페이지.
3Doodler Create+에 대해서도 마찬가지입니다: 사용자 설명서 (16 페이지)

페이지 인쇄
3Doodler Create+ 사용자 설명서
STEP 4:
Doodle Even More!
Here's everything you need to know about swapping filament
strands to change colors or filament type.
STEP 5:
Reverse and
remove plastic
02/2022
Your Name:
#MyFirstDoodle
For further guides, projects and inspiration, please refer to:
•
learn.the3doodler.com/resources/
•
learn.the3doodler.com/getting-started/
•
learn.the3doodler.com/help/
1
GREEN
Light
With the pen set to PLA, wait
for the
GREEN
light to come
on.
TIP
SNIP THOSE ENDS!
After removing a plastic strand from the 3Doodler Create+,
cut and dispose of any partially melted material at the end of
your strand. This will reduce blockages and clogging issues.
2
Flashing
GREEN
x2
Double click either speed
button. The LED light will flash
to signal plastic is reversing.
SECTION 2: GETTING STARTED
3
Once Plastic stops reversing, it is
safe to remove it from the pen
by gently pulling on the back of
the strand.
4
EN