Alto Professional TS315 Посібник користувача - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник користувача для Акустична система Alto Professional TS315. Alto Professional TS315 7 сторінок.

Features

Rear Panel

AC Input: Use the included power cable to connect this

input to a power outlet. Make sure the Power Switch is

set to off when connecting or disconnecting the cable.

Fuse: If the unit's fuse is broken, lift this tab to replace

the fuse. Replace it with a fuse with an appropriate rating

(printed under the unit's power cable input). Using a fuse

with an incorrect rating can damage the unit and/or fuse.

Note: On the TS308 model, the fuse is located next to the

power switch rather than the AC input.

Power Switch: Use this switch to power the loudspeaker

on or off. Make sure the Volume knob is set to its

minimum (counterclockwise) position before turning it on.

Power LED: This LED lights up when the loudspeaker is on.

Volume: Turn this knob to adjust the loudspeaker's volume.

When using an audio source such as a mixer, CD/MP3

player or audio preamp, follow the outer/Line level band

indicator. In most circumstances, you will not need to turn

the volume beyond 0 dB. If your audio source has

unusually low output, you may turn the Volume knob past

0 dB, but not past the Signal Limit indicator.

When using a microphone or instrument audio source,

follow the inner/Mic level band indicator. Because the

mic and instrument level is typically lower than a line

level, you can use the full rotation of the Volume knob.

Please see

Setup > Volume Control

Input: Use a standard XLR or 1/4" (6.35 mm) cable (not

included) to connect your audio source to this input.

Mix Out: Use a standard XLR cable (not included) to

connect this output to the input of another loudspeaker

(i.e., another TS3 loudspeaker).

Signal/Limit LED: This LED lights up green when an

audio signal is sent to the loudspeaker—it flashes at

lower levels and lights solidly at higher levels. The LED

lights up red when output limit/protection is active—if the

LED is lit red continuously, reduce the volume of your

audio source.

Contour: Engage (depress) this button to emphasize low

and high frequencies by +3 dB. Disengage (raise) the

switch for a flatter response for live performance or for

maximum output.

10. Ground Switch: Engage (depress) this switch to reduce

hum or noise.

to learn more.