esera automation ECO 208 PRO Посібник користувача - Сторінка 11
Переглянути онлайн або завантажити pdf Посібник користувача для Контролер esera automation ECO 208 PRO. esera automation ECO 208 PRO 18 сторінок. Professional 1-wire controller
Друкувати сторінку
Art.No.11603-48
14.3
Web server, Home page (Main Page), Maxi Interface
The Main Page provides a selection of options for configuring the Ethernet interface. The various buttons
(selection keys) take you to the corresponding submenus. These are described on the following pages.
* if the sensor or actuator supports Auto-E-Connect. For details, please refer to the operating instructions of the sensor or actuator.
All rights reserved. Reproduction as well as electronic duplication of this user guide, complete or in part, requires the written consent of
ESERA GmbH. Errors and technical modification subject to change. ESERA GmbH 2021
www.esera.de
Ethernet Interface Setting
This button takes you to the menu for setting the IP
address, SubNet and gateway number.
Protocol Settings
Pressing this button takes you to the menu for
configuring the socket interfaces 2-5.
In this menu you can set the port number of the
Modbus/TCP interfaces, for example.
Disable AP Modus
This button is only visible if the access point is
activated.
To deactivate the WLAN access point, press the
"Disable AP Mode" button or
press the "WLAN Mode" button (at least 3 seconds) on
the front panel of the unit.
If the access point is not activated, this button is not
visible. You can only activate the access point with the
"WLAN Mode" button (at least 3 seconds) on the front
panel.
Change Password
To change the password for the web server, press the
button to enter the password menu.
Factory Reset
You can reset the Ethernet interface to the delivery
status. To do this, switch to the "Factory Reset" menu.
Firmware Update
This button takes you to the update menu. This menu
allows you to update the software for the interface and
the 1-Wire interface.
Softwarestatus Ethernet interface / LogOut
Display of the software version of the Ethernet
interface installed on the unit. You can see the version
of the 1-Wire firmware via Config Tool 3.
Click on the "LogOut" button to exit the web interface.
11603-48 V1.0 R1.1 Manual
Page 11 of 18