3DUpFitters Prusa i3 MK3 Посібник з монтажу - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник з монтажу для 3D-принтери 3DUpFitters Prusa i3 MK3. 3DUpFitters Prusa i3 MK3 18 сторінок. Enclosure kit
Також для 3DUpFitters Prusa i3 MK3: Посібник з монтажу (11 сторінок)

Друкувати сторінку

Don't Panic If You See This! 

If you can't see through the plastic, please don't

panic! What you're seeing is just the plastic or paper

protective covering. You, dear customer, are way too

smart to think the plastic is ﬂawed and then call and

email us over and over again leaving increasingly irate

messages.

You see, when plastic sheets are manufactured they are

covered by either a paper (brown colored) or plastic

(white) covering to protect against scratches. Follow the

directions below to remove the cover and discover the beautiful plastic underneath. But if, in

some rare instance, the plastic arrives with a crack or scratch, either from manufacturing or

shipping, we'll of course replace it for free.

To remove the covering from an acrylic panel, lay the

panel ﬂat on a table. Then peel up a corner of the

covering and CAREFULLY and SLOWLY pull

horizontally to the sheet to reduce the lateral forces

that would bend the acrylic. Watch the Video!

https://www.3dupﬁtters.com/blogs/news/acrylic.  

How to Remove Protective Covering from Acrylic Video