3DUpFitters Prusa i3 MK3 Посібник з монтажу - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник з монтажу для 3D-принтери 3DUpFitters Prusa i3 MK3. 3DUpFitters Prusa i3 MK3 18 сторінок. Enclosure kit
Також для 3DUpFitters Prusa i3 MK3: Посібник з монтажу (11 сторінок)
Друкувати сторінкуAssemble Panels
1. The Front Door
Each of the corners on the enclosure will be held together by the connectors pictured
below. There are only two versions L and R, which can be identified by the letters
stamped on the inside. The diagonally opposite connectors are identical, i.e. Bottom
Right is the same as Top Left. In all cases the surface of the connector with the cutout
pattern faces front or back. Note the two pictures below show the inside of the front
panel.
If the holes don't seem to line up please check out this video!
https://www.3dupfitters.com/blogs/news/how-to-attach-corner-connectors
Top Left (L)
Bottom Left (Labeled R)
R-Connector From Inside
Copyright 2020 3DUPfitters LLC
Top Right (R)
Bottom Right (Labeled L)
6