ClearOne WS840D-M610 Посібник із швидкого старту - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Мікрофонна система ClearOne WS840D-M610. ClearOne WS840D-M610 13 сторінок.
Друкувати сторінку
Using the ClearOne remote software:
Editing Transmitter Parameters:
The easiest and most intuitive way to set the parameters of ClearOne transmitters and receivers is with ClearOne
Remote software. Load ClearOne Remote from the disk provided onto a computer running Windows XP or Windows
7 (32 or 64-bit) and connect to the receiver via USB or RS232. Then open ClearOne Remote and select ONLINE.
Open The Channel Edit Window:
1.
The [Click to Edit] function opens the edit window of the channel you wish to edit.
2.
Select the functions you want to edit and enter the parameter. (The various functions are described below.)
Click [OK] to save the changes and close the Channel Edit window.
3.
You will notice that the [Needs to Sync] alert is lit. This indicates that one or more parameters are in queue
in the receiver ready to be downloaded and implemented with the next transmitter Sync of the channel.
1)
Click to Edit the
channel's parameters.
ClearOne Remote provides the following functions:
1. File: File menu allows the current receiver settings to be saved to a file on your computer or for a previously
saved file on your computer to be recalled to the receiver.
2. Settings:
A. Phantom Power: Turn antenna phantom power on or off. Default = ON.
B. Redundancy: Set adjacent pairs of receivers to redundancy mode. Default = OFF.
C. Headphone Mode: Toggles the mixed output jack from headphone mode to a balanced line output.
Default = Balanced line output.
3. Ethernet Settings: If using Ethernet, assign the proper IP address to the receiver or, enable DHCP . Default =
DHCP enabled.
4. RF Scan - RF Plot: Shows the RF strength of each antenna in a ClearOne system and shows if there is out-
side interference.
5. Presets: saves settings to receiver memory or recalls settings from receiver memory.
6. GPIO: Assign contact closure functions and setup for RS232 control. Default = RS232 enabled.
7. Alerts: Send alerts to authorized personal when preventive maintenance is required of if there is a fault. De-
fault = none.
8. Help:
A. Tutorials: Setting parameters, Antenna Application Guide, etc.
B. About: Shows vital statistics for each component of the system.
Default Transmitter Preamp Gain Settings:
Transmitter + Last 4 digits of serial Number
3
2)
Select the new parameter values and
click "Send Changes to Receiver and
Close".
BLT XXXX
HH XXXX
PDM XXXX
BDM XXXX
3)
Default Transmitter Preamp Gain
10 dB
H18 = 0dB
10dB
20dB
The "Need To Sync" alert is lit. Sync the transmitter
to apply the selected parameters.
Key:
BLT = Beltpack
HH = Handheld Mic
PDM = Gooseneck / Podium Mic
BDM = Tabletop / Boundary Mic