ClearOne WS840D-M610 Посібник із швидкого старту - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Мікрофонна система ClearOne WS840D-M610. ClearOne WS840D-M610 13 сторінок.
Друкувати сторінку
How to sync transmitters with the receiver:
How to sync transmitters with the receiver:
1. Locate the IR (infrared) Sensor on the transmitter.
IR
IR
2. Power on the transmitter.
3. Hold transmitter about 6 inches from the corresponding receiver module with the IR sensor aimed at the
receiver module.
4. Simultaneously press the two buttons on the bottom of the corresponding receiver module to start sending
the IR signal. "SYNCING" shows on the receiver OLED when the IR signal starts. "SYNC OK" shows when
the sync is successful. Repeat the procedure if the receiver display shows "SEARCHING". It is not necessary
to press any buttons on the transmitter during the procedure. Note: You may get a "SEARCHING" message
if the receiver antennas are not in the same room as the receiver. In this case verify that either the transmitter
display shows "Sync Good" OR the green LED on the transmitter flashes. Also, make sure to dock each
transmitter after syncing to avoid 2 transmitters being synced to the same receiver frequency.
How to read the LED:
1.
The gooseneck or
boundary mic is in use:
RED = AUDIO MUTE
l
GREEN = AUDIO PASSES
l
BLINKING RED SLOW= BATTERY IS LOW
l
BLINKING GREEN = SYNC SUCCESSFUL
l
NOTE: All transmitters placed in the charging dock will "RF MUTE".
4
ON/OFF
USB
IMPORTANT: Turn off all transmitters, except the one that is being synced, to
avoid two transmitters being synced to the same receiver frequency.
2.
The gooseneck battery cassette
is in the docking station:
RED = CHARGING
l
OFF = FINISHED CHARGING
l
BLINKING RED = CHARGING ERROR
l
(RE-SEAT TRANSMITTER AND CHECK THE BATTERIES)
IR
USB
IR
ON / OFF
NOTE: The transmitter and receiver are assigned a new,
random AES 256-bit encryption key every time they are synced.
3.
The boundary mic is in the
docking station:
RED change to AMBER = CHARGING
l
GREEN = FINISHED CHARGING
l
GREEN & RED BLINKING = CHARGING ERROR
l
(RE-SEAT TRANSMITTER AND CHECK THE BATTERIES)
IR
4.
Hand-held mic or belt-pack
is in the docking station:
The OLED shows the battery status
l