ClearWater OzoneMax OZ-SPA Посібник з монтажу та експлуатації - Сторінка 3

Переглянути онлайн або завантажити pdf Посібник з монтажу та експлуатації для Освітлювальне обладнання ClearWater OzoneMax OZ-SPA. ClearWater OzoneMax OZ-SPA 8 сторінок. Vacuum-ultraviolet pool ozone systems

Друкувати сторінку

Power Source/

TimerBox

The OZ-SPA system is comprised of a power box and a venturi injection kit , which needs to be

installed at the very end of the return line (after the filter, ionizer electrode chamber, heater, etc.).

The ozone unit will need to be installed to a post or wall within six (6) feet of a 115 or 220VAC timer,

electrical box or a 115V receptacle. This location will need to be within six (6) feet of location of the

venturi injector. This location should be mounted at least one (1) foot above maximum water level

and preferably out of direct sunlight. The ozone unit should be no closer than five (5) feet from a

body of water.

Mount the OZ-SPA unit to a post or wall using the four mounting screw holes in the enclosure base.

The unit may be mounted horizontally or vertically, however it is recommended that the vent holes not

face upward and be directly exposed to rainfall. The location of the box must be within six (6) feet of

the location of the venturi, which is plumbed on the return line. The unit should be mounted at least

one (1) foot above maximum water level and preferably out of direct sunlight. The power box should

also be located no closer than five (5) feet from a body of water.

C. Tools & Materials Required

• Bullet Level

• Hacksaw or Pipe Cutter

• PVC Cleaner/Primer

• Screwdrivers, Flat & Phillips

D. Site Survey

OZ-SPA Unit

within 6 feet

E. Installing the Power Box

• Drill & Drill Bits

• PVC Cement

• Utility Knife

• Screws & Anchors

within 6 feet

Venturi Injector