Aluprof DC1690 Посібник з експлуатації - Сторінка 2
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Перемикач Aluprof DC1690. Aluprof DC1690 2 сторінки. Plaster switch with radio receiver
Також для Aluprof DC1690: Посібник з програмування (4 сторінок)
Друкувати сторінку
3. SWITCH CONFIGURATION
If pause between pressing buttons is longer than 60 seconds transmitter will exit setting mode
3.1. Memorizing the transmitter
Turn the power on
3.2. Kasowanie nadajnika
Turn the power on
3.3. Mode change (with or without suport)
Press the UP and STOP buttons
Turn the power on
3.4. All programmed transmitters have been deleted
Turn the power on
2
Press the UP and DOWN
buttons simultaneously for
2 seconds
The LED should blink
Press the UP and DOWN
buttons simultaneously
for 2 seconds
The LED should blink
simultaneously for 5 seconds
The operating mode has been
Press the DOWN and STOP
buttons simultaneously for
All programmed transmitters
5 seconds
Press „STOP" button
Pres the „UP" buton on the
The LED is lightining
Press „STOP" button
Pres the „DOWN" buton
The LED is lightining
on the remote controller
Executing the procedure
again will cause return to the
The LED will blink 3 times
changed
The LED will blink 3 times.
have been deleted
The LED will blink 3 times
The transmitter has been
remote controller
The LED will blink 3 times
The transmitter has been
deleted correctly
previous mode.
We reserve the right to any technical change. Valid on 2019.09.18
added correctly