Blue Clean AR 2N1-Q Інструкції з монтажу, догляду та використання - Сторінка 14
Переглянути онлайн або завантажити pdf Інструкції з монтажу, догляду та використання для Мийка високого тиску Blue Clean AR 2N1-Q. Blue Clean AR 2N1-Q 20 сторінок. Electric pressure washer 2050 psi
Друкувати сторінку
OPERATING INSTRUCTIONS
Detergents
• Use detergents designed for power washers.
Hardware stores or home centers also have power
washer detergents for different cleaning projects. The
cleaning solution should be the consistency of water
in order to prevent clogging your detergent bottle and
nozzle.
• This system applies detergent under low pressure.
The cleaning power of the detergents is enhanced
when applied with low pressure and enough time is
given to break down dirt and grime. The combination
of low pressure and chemical action is very effective
and can be better than scrubbing if applied properly.
Always spray detergent on a dry
CARE AND MAINTENANCE
Cleaning Garden Hose Adapter
• The screen inside the adapter should be cleaned
periodically. Remove it by dragging a thumb over the
screen with enough pressure to pull the screen and
washer out. Rinse it with clean water and then place
it back in the adapter.
14
surface. Do not pre-soak area. Wetting the surface
first dilutes the detergent and reduces its cleaning
ability. Do not allow detergent to dry on surface. On
vertical surfaces being cleaned, apply detergent
to lower surfaces and work your way up to prevent
detergent from causing streaks in the dirt and grime.
Rinse detergent by pressure washing from bottom up
for same reason.
• If a stain is particularly tough, it may be necessary
to reapply the detergent and use a bristled brush to
scrub the stain. Power washing after brushing should
successfully clear the stain.
Cleaning Nozzles
• A clogged or partially clogged nozzle can cause
significant reduction of water pressure coming out
of the nozzle and/or cause the unit to pulsate while
spraying.
• Turn off the unit.
• Turn off the water supply to the unit.
• Relieve any pressure trapped in the hose by
squeezing the trigger 2 - 3 times, then lock the spray
gun by turning the dial to lock ("3" and "9" position).
• Remove the nozzle from the spray gun.
• Using the nozzle cleaner wire provided (or an unfolded
paper clip), insert the wire into the nozzle hole and
move back and forth until debris is dislodged.
• Back flush water through the nozzles using garden
hose and highest pressure available (either standard
water nozzle or use your thumb over the nozzle to
create water pressure for back flush).