Etaluma LS460 Посібник із запуску - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник із запуску для Мікроскоп Etaluma LS460. Etaluma LS460 14 сторінок. Lumascopes with lumaview (for use with ls560, ls460, ls600, ls620, ls720)
Друкувати сторінкуThis document is available for download at
Note that all steps are described for LS560 but apply to both LS560 and LS460 unless specified otherwise.
I.
Hardware: Setup of LS560
A. Items Included With LS560 (and LS460)
USB power/communication cable
•
Fluorescence shroud (not included with LS460)
•
External power supply/cord with country-specific plug (not included with LS460)
•
B. Optional Accessories (purchased separately)
Phase Contrast Accessory, Manual LS Microscopes (Olympus)
•
Holder for 35 mm Petri dishes, fits inside Holder for 60 mm Petri dishes
•
Holder for 60 mm Petri dishes & Terasaki plates, SBS outer dimensions
•
Holder for microscope slides & 50 mm Petri dishes, SBS outer dimensions
•
Holder for 4 microscope slides in parallel, SBS outer dimensions
•
Lumaquant, Image analysis software
•
Microvolution, Deconvolution software
•
C. Recommended Computer Specifications
Windows 7, 8, 8.1, or 10; Core i5 or better Processor; 500 GB minimum solid state drive (recommended
for time-lapse and live video capture); 4 GB minimum RAM, single 4K monitor or two with 1080p HD
resolution
D. Placing the LS Microscope
1. Remove LS560 from the shipping box (save box and packing materials) and place on a lab bench or
counter in a standard room environment. If the LS560 will be used in an incubator or hood, it is
recommended that the initial setup be carried out in a room with ambient conditions before placement
into the specialized environment. See Section I.L. for information about live cell imaging with the LS560
in an incubator.
2. Wait to connect the USB cable to the computer until Lumaview is installed (see Section I. J-K. below).
E. Phase Contrast
1. If using the Phase Contrast Accessory LS600/500/400-Series (Phase
Accessory), remove it from its shipping box (save box and packing materials).
Ensure that the Phase Accessory adaptor is attached to the rear tab of the
LS560 Accessible Deck (see photo). Attach the Phase Accessory by inserting
the base of the arm into the Phase Accessory adaptor. Ensure it is fully
seated and tighten the thumb screw on the bottom of the adaptor.
2017.11.20
http://etaluma.com/products/downloads.
LS560/460 Startup Guide
Phase Accessory adapter
3